Lynxmotion AL5D-PLTW Manual page 36

Step C2 : The white horn which comes preinstalled on the Hitec 225 and 422 servos will not be
needed... HOWEVER, the output spline needs to remain zeroed, as shown in the image to the
left. Remove (and keep) the screw holding the horn in place. Ensuring the horn is in exactly this
orientation, pull it up and off the servo. Repeat for the second servo. Keep the center screws as
they will be needed in subsequent steps. Do not remove the horn from the 645 servo.
RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2
35