Updating Iq System Software; Applying An Automatic Iq System Software Update Manually - SMART Board SBID-MX265 Installation And Maintenance Manual

CHAPTER 8
TROUBLESHOOTING
8. The upgrading software screen appears.
If the update includes an upgrade to the touch firmware, don't touch the screen during an
update.
9. Using the switch on the back of the display, turn off the display.
10. Wait 10 seconds.
11. Using the switch on the back of the display, turn on the display.

Updating iQ system software

When the iQ appliance is connected to the Internet, it updates its system software automatically.
When a system software update is available, the iQ appliance downloads the update in the
background then waits for four hours of inactivity. When that happens, the display shows a
two-minute countdown before beginning the update. The countdown can be interrupted at any
time. The update begins when the countdown finishes. The display shows a blank screen for four
minutes. When the update is complete, the display shows the Whiteboard and any content that
was on Whiteboard before the update.
When the update is installing, touch, the front control panel and remote control will not respond.
NOTE
You can configure your organization's network to allow or prevent automatic system software
updates (see Connecting to a

Applying an automatic iQ system software update manually

If the iQ appliance has downloaded the system software update but hasn't yet applied the update,
you can start the update process manually from Settings.
To apply an automatic iQ system software update manually
1. From the Home screen, tap Settings
The Settings window appears.
2. Scroll to Auto Update.
3. Under Check for Updates Now, tap Apply Update Now.
52 smarttech.com/kb/171257
network).
.