CHAPTER C
REMOTELY MANAGING THE DISPLAY
To use the room control system to get information about the display or to adjust display settings,
type commands after the command prompt (>), and then wait for the display's response.
CORRECT
>get volume
volume=55
>
If you type a command that the room control system doesn't recognize, you receive an invalid
command response.
The example contains an extra space in the volume command.
INCORRECT
>set vol ume=65
invalid cmd=set vol ume=65
>
NOTES
Use ASCII formatted commands.
l
Commands aren't case-sensitive.
l
You can use the BACKSPACE key when typing commands.
l
Review each entry carefully before you press ENTER.
l
Don't send another command until you receive the response and the next command
l
prompt.
To identify the current value of a setting
Use a get command.
This example shows how to get the display's current volume setting:
>get volume
volume=55
>
70
smarttech.com/kb/171257