Federal Communication Commission Interference Statement - SMART Board SBID-MX265 Installation And Maintenance Manual

IMPORTANT INFORMATION
The accessory slot's maximum available power is 60 W. The slot is not a limited power
l
source. To reduce the risk of fire, make sure that accessories connecting to the slot satisfy
the fire enclosure requirements of IEC 60950-1.
You must connect the USB cable that came with the display to a computer that has a USB
l
compliant interface and that bears the USB logo. In addition, the USB source computer must
be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or UL Mark(s) for
CSA/UL 60950. This is for operating safety and to avoid damage to the display.
IMPORTANT
The following are the normal operating requirements for the display, including AM module
l
and speakers:
Model
SBID-MX265
SBID-MX275
SBID-MX286
For additional requirements and other information, refer to the display's specifications (see
l
More information on page 8).
Federal Communication Commission
interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAUTION
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
iii smarttech.com/kb/171257
Power requirements
100V to 240V AC, 50 Hz to 60 Hz, 115 W max
100V to 240V AC, 50 Hz to 60 Hz, 224 W max
100V to 240V AC, 50 Hz to 60 Hz, 265 W max