SMART Board SBID-MX265 Installation And Maintenance Manual page 85

CHAPTER C
REMOTELY MANAGING THE DISPLAY
Get command
get volume
get mute
get fwversion
get serialnum
get partnum
73 smarttech.com/kb/171257
Set command
set volume[Value]
Where [Value] is one of the following:
+[Value]
l
-[Value]
l
=[0–100]
l
set mute[Value]
Where [Value] is one of the following:
=on
l
=off
l
fwversion=[Value]
Where [Value] is the firmware version.
serialnum=[Value]
Where [Value] is the display's serial
number.
NOTE
If multiple displays are connected, the
response includes the serial
numbers for all displays, separated
by commas.
partnum=[Value]
Where [Value] is the part number,
including the revision.
Response
volume=[Value]
Where [Value] is a number between
0 and 100
mute=[Value]
Where [Value] is one of the following:
on
l
off
l