Cleaning The Screen; Cleaning The Touch Sensors - SMART Board SBID-MX265 Installation And Maintenance Manual

CHAPTER 7
MAINTAINING THE DISPLAY

Cleaning the screen

Follow these instructions to clean the screen without damaging its anti-glare coating or other
product components.
CAUTION
Do not use permanent or dry-erase markers on the screen. If dry-erase markers are used on
l
the screen, remove the ink as soon as possible with a lint-free, non-abrasive cloth.
Do not rub the screen with dense or rough material.
l
Do not apply pressure to the screen.
l
Do not use cleaning solutions or glass cleaners on the screen, because they can deteriorate
l
or discolor the screen.
To clean the screen
1. Turn off any connected computers.
2. Turn off the display (see Turning the display off and back on on page 38).
3. Wipe the screen with a lint-free, non-abrasive cloth.
NOTE
Alternatively, you can use a damp cloth with a drop of dish soap.

Cleaning the touch sensors

The display uses infrared (IR) transmitters and sensors around the display's perimeter between the
screen and the frame. Dust buildup on the protective plastic can impair touch performance. Inspect
these areas for dust and clean them every week.
CAUTION
Do not use compressed air to clean the sensors or borders.
l
Do not use water or cleaning agents to clean the touch sensors.
l
Do not apply too much pressure when cleaning the display because you can damage the
l
plastic.
36 smarttech.com/kb/171257