Cleaning The Screen; Cleaning The Camera Windows And Reflective Tape - SMART Board 6065 HD Installation And Maintenance Manual

CHAPTER 6
MAINTAINING THE DISPLAY

Cleaning the screen

Follow these instructions to clean the screen without damaging its anti-glare coating or other
product components.
CAUTION
Do not use permanent or dry-erase markers on the screen. If dry-erase markers are used on
l
the screen, remove the ink as soon as possible with a lint-free, non-abrasive cloth.
Do not rub the screen with dense or rough material.
l
Do not apply pressure to the screen.
l
Do not use cleaning solutions or glass cleaners on the screen, because they can deteriorate
l
or discolor the screen.
Avoid touching the reflective tape between the screen and the frame, and ensure that this
l
strip stays dry. Damage to this strip affects touch interactivity.
To clean the screen
1. Turn off any connected computers.
2. Turn off the display (see Turning the display off and back on on page 37).
3. Wipe the screen with a lint-free, non-abrasive cloth.
NOTE
Alternatively, you can use a damp cloth with a drop of dish soap.

Cleaning the camera windows and reflective tape

The display's DViT® (Digital Vision Touch) technology uses four cameras in the corners of the frame
and the reflective material between the screen and the frame. Dust buildup on the camera
windows or reflective tape can impair touch performance.
Inspect these areas regularly for dust, and clean them if any obvious buildup has occurred.
CAUTION
Dust buildup on the camera windows and reflective tape will degrade touch performance.
l
SMART recommends that you inspect the camera windows and reflective tape for buildup
and clean weekly.
Do not use compressed air to clean the camera windows or borders.
l
34 smarttech.com/kb/171204