Spindle Service - Progressive Turf Equipment Pro-Flex 120 Operators Manual & Parts Lists

Pro-Flex 120 Series Operator's Manual
BLADE SHARPENING
Use gloves when handling mower blades. Blades can be very
sharp.
IMPORTANT! When sharpening blades, be sure material removed is
equal on both sides of the blade. Unbalanced blades will cause
excessive vibration leading to cracks in machine components.

Clean all material from the blade prior to sharpening and
balancing.

Grind or file blades following original pattern as shown.

Sharpen to a razor edge. Do not sharpen back side of blade.
Use the supplied cone balancer to verify blade balance. When
the blade is correctly balanced, the blade will remain horizontal.

SPINDLE SERVICE

Each spindle is supported by two ball bearings. No adjustment of
clearance is required. Running clearance is pre-set during assembly
by tightening the 1" NF left hand nut on top of the pulley.
Periodically inspect blade spindles by grasping pulley, and moving
from side to side. If any free play is noted, replace or repair.
SPINDLE ASSEMBLY REMOVAL
1) Relieve tension from belt, and remove belt from the spindle
pulley.
2) Raise the mower decks into the service position and ensure the
deck safety locks are secure
3) Remove blade from spindle.
4) From under the deck, loosen the four nuts that hold the spindle
assembly to the deck.
5) Remove the complete spindle assembly and pulley out through
the hole in the deck.
SPINDLE ASSEMBLY INSTALLATION
Reverse above procedure. Be sure spindle mounting area of deck is
clean of any foreign material before attaching spindle assembly.
40