Allen-Bradley Compact GuardLogix 5370 User Manual page 37

The RSWho dialog box appears and includes the USB driver.
4. Right-click the EtherNet/IP module and choose Module Configuration.
The Module Configuration dialog box appears.
5. Click the Port Configuration tab.
6. For Network Configuration Type, select Static to assign this configuration
to the port.
IMPORTANT If you click Dynamic on a power cycle, the controller clears the
7. Type the new IP address and Network Mask.
8. Click OK.
As with all configuration changes, make sure that you are using the SD card in a
way that does not overwrite the IP address at the next controller power cycle.
For more information on using the SD card, see
Rockwell Automation Publication 1769-UM022C-EN-P - June 2018
Complete the Controller Setup
current IP configuration and starts to send BOOTP requests.
Chapter
Chapter 3
13.
37