General Programming Hints - Thermoplan Black&White3 CT Technical Manual

General Programming Hints

Enter PIN
****
7 8 9
4 5 6
1 2 3
NAVIGATION
PRODUCTPARAMETER
TEST-COFFEE
DOUBLE-PRODUCT kEyS
© 2009 by Thermoplan AG, Subject to change
Technical Manual
Touch the upper left corner on the Touchscreen. The access window for the
Service-Code appears.
Service-Code for programming level: 1111
Press the „step" key to enter the programming menus.
Step forward
Press „step"-key.
Step backwards
Press „back"-key.
Settings
Set parameters with the „Plus" or „Minus" key.
Save settings
Press „step" key.
To set the several productparameter select firstly the product and then set with
the „Plus" or „Minus" key.
It is necessary to test the values, changed in the programming mode, imme-
diately. By pressing the corresponding product key for 2sec., a test coffee
can be supplied without leaving the programming mode.
Function is only available in the menu:
Powder quantity, prebrew time, relax time and press after
For the test coffee, the waiter-, cash- and coin-systems are not active.
All models have 8 or 12 product keys.
With the „Double" key two or more cups of the desried beverage can be
produced.
Double product: „X"
Multiple product: „2" - „9"
Important hint
Double products can also be programmed individually on one single button.
Please note that double-product settings or changes in the menus
- Water quantity
- Coffee aroma
- Powder quantity
- Bypass
are made in the program „1 cup".
Double product in one brew cycle
Multiple products with one brew cycle
for each product
REV-4
SECTION 3
Step
Step
Back
+ -
Step
Product Plus-/Minus
2x
3.29