Table of Contents
Advertisement
Menu Description
Menu
38.
Mill change
39.
Milksequence
40.
Milk type
41.
Bypass
1 cup
42.
Bypass
2 cups
43.
Multiple
© 2009 by Thermoplan AG, Subject to change
Technical Manual
In the parameter Mill Change by pressing the „Minus" or „Plus" key the beverage key can be
assigned to grinder 1 or grinder 2. Press the selected beverage button, then press the „Plus" key
and the beverage will be produced from grinder 2. By pressing the „Minus" key the beverage is
produced from grinder 1.
Note:
The factory default setting has all coffee beverages programmed to be pulled from grinder 1.
A beverage button that is programmed on grinder 2 is fixed on grinder 2. The grinder default
change to grinder 1 is not possible.
However it is possible to pull a beverage from grinder 2 that is assigned to grinder 1.
In the parameter Milksequence by pressing the respective product beverage key with the „Minus"
or „Plus" key, the sequence of the milk/coffee cycle can be programmed: „At begin", „During"or
„At the end" of the coffee beverage.
Note:
For an optimal milkfoam we reccomend the setting „At begin".
In the parameter Milk type you can set for every single milk product, whether it takes the milk
from „Milk 1" or „Milk 2". Choose a milk product and change between „Milk 1" and „Milk 2" by
pressing the „Minus" or „Plus" key.
Note:
„Milk 2" only works if menu „Milklevel Control" is set to „Milk 1+2".
In the parameter Bypass by pressing the „Minus" or „Plus" key the percentage of the water can be
programmed to bypass the coffee cake.
Press the desired product key. By pressing the „Minus", (less), or „Plus", (more) key, the percentage
of the water passing the ground coffee compared to the total water quantity is programmed.
Adjustable range is 0-99% amount of water passing through the ground coffee, respectively no
Bypass.
Note:
For example if a percentage of 30% is programmed it means that 70% of the total amout of water
passes throught the ground coffee, where as 30% as hot water bypassing the ground coffee.
In the parameter Multiple by pressing the „Minus" or „Plus" key Mulitple beverages can be
produced.
The multiple feature can be programmed to each beverage.
Example: If you assign to a beverage product key 3 mulitple beverages, by pressing the product key
once it will automatically produce 3 beverages one after the other.
Multiple beverages can also be produced by using the default button Multiple.
Example: If one of the product keys is programmed with „Multiple" it is possible by using the
Double Product key to multiply 2 - 9 products dispensed.
Description
REV-4
SECTION 3
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
3.34
Hide quick links:
Advertisement
Table of Contents
