Thermoplan Black&White3 CT Technical Manual page 32

Menu Description
Menu
17.
Coffee temp.
90°C 194°F
18.
Coffeereadylevel
80°C 176°F
19.
key selection
20.
Powder quantity
M1 1 cup
21.
Powder quantity
M1 2 cups
22.
Powder quantity
M2 1 cup
23.
Powder quantity
M2 2 cups
© 2009 by Thermoplan AG, Subject to change
Technical Manual
By pressing the „Minus" or „Plus" key in the parameter „Coffee Temperature" the water tempera-
ture in the coffee boiler can be programmed between 78 and 99 degrees.
By pressing the „Minus" or „Plus" key in ther parameter Coffee Ready Level you can set the
temperature at minimum temperature the coffee output will be disabled. If the temperature in the
boiler is below the set temperature level the message „Please Wait" appears on the display and
there will be a waiting time until the boiler has reached the programmed temperature level. The
temperature can be set between 70°C (158°F) and 91°C (195.8°F), however it will always be 8°C
(14.4°F), under the actual set temperature. The setting range changes proportionally to the preset
coffee temperature.
In the parameter Key Selection by pressing the „Minus" or „Plus" key the beverage keys can be
changed or reallocated.
Press product key to be changed and press the Plus key until the desired product appears on the
display.
Note:
It is possible to assign 2 of the same beverage products to different product selection keys.
As an example if the milk key is not used a second Cappuccino, coffee or tea beverage can be
programmed.
Important:
If a new product is assigned the basic parameters will automatically default to the factoy setting.
The basic values, such as water quantity must be reprogrammed.
In the menu Powder Quantity M1 1 cup you can change the powder quantity of grinder 1 by
pressing the „Minus" or „Plus" key.
Press the product key you wish to change. Then by pressing the Plus key you increase the
powder quantity, alternatively by pressing the „Minus" key you reduce the powder .
Example to reduce the amount of ground coffee
If you adjust the Powder Quantity do not change value by more than 2 units at the time. For exam-
ple if the value on the scale says 30, (appr. 12 gr), press the „Minus" key back to 28. Exit program
parameter and pull 4 test coffees for tasting. If the taste is not satisfactory return to the parameter
Powder Quantityt and repeat the process, i.e decrease the value from 28 down to 26.
Test Product:
If you press and hold the respective product button for 2 seconds a test product will
automatically be produced to check the programmed values.
Note:
By double-clicking the respective product button it will automatically grind the amount of time
programmed to weigh out the ground coffee.
Description
REV-4
SECTION 3
X X X X
X X X X
X X X X
X X X X
3.32