By Thermoplan Ag, Subject To Change - Thermoplan Black&White3 CT Technical Manual

Replacing the EPROM
Save your settings on a CF-Card!
Afterwards turn machine off.
1
Turn the lever of the bean hopper
clockwise to unlock it. Do this with
both bean hoppers.
4
1.
2.
Use your fingertips to press the 2
locks on the mechanical module
inwards and pull out the whole
7
module
Disconnect all wires on the control
board. Carefully remove the EPROM
with the according tong and mount
10
the new EPROM.
© 2009 by Thermoplan AG, Subject to change
Technical Manual
Remove grounds drawer and turn
off machine. Use the appliance key
to remove the front panel of the
2
machine.
Use both hands to pull out the 2
bean hoppers
5
1.
Remove the screw located directly
under the CPU-cover
8
Take care that you mount the
EPROM in the correct position, and
all pins fit in the right holes!
11
REV-4
SECTION 3
Use holes (left and right) to lift up
the front. Unhook the two locks with
your fingertips. Lift up the front to the
3
top position and release the locks.
Disconnect the 2 tubes which lead
into the coffee outlet
6
Remove the CPU-cover
9
Do all the steps in reversed order to
build up your machine again. Save
your settings back from CF-Card to
12
machine (EPROM)!
3.21