Related Manuals for Thermoplan BLACK&WHITE 3 FOX2
Summary of Contents for Thermoplan BLACK&WHITE 3 FOX2
- Page 1 Technical Manual CTM / CBTM SECTION 6 DISPLAY MESSAGES FOX2 REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 2 Technical Manual Document: Display messages SECTION 6 Modification journal Revision: Date: Modifications Initials: 2010-01-20 First edition, new document Overview modification REVISION REVISION REVISION Changes in content, corrections New paging REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 3 Technical Manual Index SECTION 6 User messages Index Picture messages 6.5 - 6.7 Text messages 6.8. - 6.11 REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 4 For the following text messages the picture „Product out!“ appears on the touchscreen. Enter code „111111“ to see the message. Flow error Change water filter Piston error Service required Drain tub Overtime error If the machine had to be shut down, wait for 10 seconds before restarting. REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 5 „system test“. Push outlet up to remove the grounds drawer. Empty it and put it back after- wards. To reset the counter auto- matically, wait for 5 seconds before reinserting. REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 6 Picture messages Solution Open the cover of the hopper and refill it with fresh coffee beans. Open refrigerator and refill milk con- tainer with milk. Pull down the command desk and close it. REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 7 After the cleaning the machine enters the standby mode. Press continue to go back to the product screen. A serious error occured. Contact the service technician. REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 8 Close command unit (snaps in audibly) • Defective solenoid switch of command unit or bean hopper – Check solenoid switches • No cleaning was performed since 24 hours Please – Perform daily cleaning clean unit REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 9 • Info message, refrigerator temp is lower than 4 °C RF temp – if on short notice, only as info too low – if permanent, check refrigerator for freezing – Check the refrigerators temperature sensor REV-0 © 2010 Thermoplan AG, Subject to change...
- Page 10 • Change hydraulic module • Machine has reached a preprogrammed number of brew cycles PM required – Perform preventative maintenance as required – Reset counter REV-0 6.10 © 2010 Thermoplan AG, Subject to change...
- Page 11 • Coffee flow is too slow ( > 2 Min.) Overtime error – Check grind setting and weight according to parameters • Water flow blocked – Check brew valve on hydraulic module • Eventually change hydraulic or mechanical module 6.11 REV-0 © 2010 Thermoplan AG, Subject to change...
Need help?
Do you have a question about the BLACK&WHITE 3 FOX2 and is the answer not in the manual?
Questions and answers