Table of Contents
Advertisement
Menu Description
Menu
54.
Milkrevolution
900rpm (1/min)
55.
Foamrevolution
1800rpm (1/min)
56.
Turn off heater before
Milkbeverage end
2000 ms
57.
Minimal Rinsetime
after Milkbeverage
3200 ms
58.
Rinsetime after
Milkbeverage hot
5000 ms
59.
Rinsetime after
Milkbeverage cold
3000 ms
60.
Milksuckintime
normal
4500 ms
61.
Milksuckintime
after milkrinse
7500 ms
62.
Rinstime after
milkproduct
0 ms
63.
Backrinsetime
5min rinse
1300 ms
64.
Purgevalve
during cleaning
not active
65.
Milklevel
Control
Milk 1
© 2009 by Thermoplan AG, Subject to change
Technical Manual
By pressing the „Minus" or „Plus" key you can change the revolution of the milk pump during milk
products.
By pressing the „Minus" or „Plus" key you can change the revolution of the milk pump during milk
foam products.
The heater turns off two (2) seconds before the milk product ends.
This secures, that the milk inside the „wendel" system does not burn.
If during a coffee-milk product the coffee product runs longer than the milk product, the machine
shortly flushes the wendel, to ensure the milk does not burn inside the wendel. The pressure of the
coffee product will be reduced for the setted time.
After a hot milk product, rinse water flows through the milk system for the setted time to clean the
system (through the drain valve, not in the cup).
After a cold milk product, rinse water flows through the milk system (except the wendel) for the
setted time to clean the system (through the drain valve, not in the cup).
After the start of a milk product, the drain valve stays closed to drain the remaining water (from the
rinse process) in the milk system.
This secures, that no water flows in the cup.
If a „5 minute rinse" was performed and you press a milk product, the drain valve stays closed
for the setted time to drain the remaining water in the milk system. This ensures, that only the
remaining water inside the milk pipe between the drain valve and the spout flows in the cup (this
water cannot be eliminated).
If the milk is empty during a milk product (machine demands to exchange milk bottle), a backrinse
of the milk system is initiated to serve the milk detection box with fluid. If the operater now pushes
the „Continue" key, the machine can finalize the started milk product.
This menu sets the time of the backrinse of the 5 minute rinse, cold start rinse or normal rinse.
This menu must not be changed (disappears in future)!
In this menu the milk level control can be activated or deactivated. For two kinds of milk both can
be set individually. The value can be set to:
Milk 1: one kind of milk sort (default setting)
Milk 1+2: two kinds of milk sort
Milk 1 with level: one kind of milk sort with an additional level sensor (only in combination with fridge)
OFF: Milk level not controlled (never use this function, danger of milk burning in wendel system!)
Description
REV-4
SECTION 3
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
3.36
Hide quick links:
Advertisement
Table of Contents
