Redline AN-30 System User Manual page 61

Returns: remote alarm indication
tdm get tdmsais, params: SN
Returns: alarm indication signal
tdm get tdmses, params: SN
Returns: errored seconds
tdm get tdmsfec, params: SN
Returns: framing error counter
tdm get tdmscvc, params: SN
Returns: code violation counter
Show operations
These commands are:
- tdm showstat
- tdm resetstat
tdm showstat, params: STAT
This command requests the module specific statistics selected by STAT.
If STAT is not valid, the command will return non-ack.
STAT
0
1..4
5..32
33
34
35
tdm resetstat, params: STAT
This command resets the module specific statistics selected by STAT.
If STAT is not valid, the command will return non-ack.
STAT
0
1..4
5..32
33
34
35
Redline Communications
Definition
reserved for all statistics (not yet
implemented)
TDM statistics on serial interface 1..4
reserved for many serial interfaces
Ethernet Statistics
Ethernet Properties
Debug Statistics
Definition
reserved for all statistics (not yet
implemented)
TDM statistics on serial interface 1..4
reserved for many serial interfaces
Ethernet Statistics
not applicable
Debug Statistics
Page 61 of 80
AN-30 System User Manual
.....solving the first mile challenge