Redline AN-30 System User Manual page 47

tdm save, no params
This command copies the temporary configuration image to the running configuration
image.
Since all commands falling under general, serial interface, and DS0 bundle categories,
modify only the temporary configuration image, the tdm save command is used to
activate these changes, by copying them to the Running configuration image.
Warning:
This command will reset operation of a working AN-30 link disrupting all
communications while the unit re-initializes to the new configuration. On a production
network this command should only be issued during the off hours of a maintenance
window.
The tdm save command triggers the following actions:
• The modified temporary configuration is checked.
• If valid, config is saved to running config and software is restarted.
• If configuration is not valid (i.e.: serial interface pointed by "syncon" is
disabled), an error code is returned containing 3 fields: LEVEL + NUMBER +
ERROR_ID and "save" command is ignored.
The meaning of the error code bytes is presented in the following:
Level
0
1
2
Level Number
General 0
Serial 1..4
Bundle 1..128
Level Error ID
General
Serial
Bundle
Redline Communications
General Level
Serial Interface Level
Bundle Level
Always 0
the number of the misconfigured serial interface.
the number of the misconfigured bundle.
0 GENERAL_SYNCON
1 GENERAL_TOO_MANY_BUNDLES
2 GENERAL_LINE_TYPE
0 SERIAL_BUNDLES_OVERLAP
1 SERIAL_TOO_MANY_BUNDLES
2 SERIAL_CODING
3 SERIAL_FRAMING
0 BUNDLE_TS0
1 BUNDLE_MASK
Page 47 of 80
AN-30 System User Manual
Definition
Definition
Definition
.....solving the first mile challenge