Figure 3: Front Panel - Wireless; Figure 4: Front Panel - Ethernet - Redline AN-30 System User Manual

AN-30 System User Manual

Figure 3: Front Panel - Wireless

Link – The "Link" LED lights solid green when the radio link to the remote terminal is
established. The LED will turn off if the link is lost.
Signal – The "Signal" LED lights solid green if the system is operating at the configured
Uncoded Burst Rate. See section on for a detailed description.
C) Ethernet Status Indicators
The Ethernet status portion of the front panel display consists of three LEDs; Link, 100,
FD, as shown below.
Figure 4: Front Panel – Ethernet
Link – The "Link" LED illuminates solid green when the Local Area Network (LAN)
connection is established, and there is no traffic. The Link LED will flash when the
Local Area Network (LAN) connection is established, and there is traffic.
100 – The "100" LED lights solid green when the Ethernet port is operating at 100 Mb/s.
The LED will not illuminate if the port is operating in 10 Mb/s mode. The Ethernet port
automatically selects the speed through auto-negotiation with either the host
computer/server or router/switch.
FD – The "FD" LED is used to indicate if the Ethernet link is in full duplex and half
duplex mode. It illuminates solid green for full duplex, and is set off to indicate half
duplex mode. On a shared Ethernet networks, collisions are also indicated through the
intermittent flashing of this LED. The system automatically selects the duplex mode
through auto-negotiation with the host computer or switch.
Page 15 of 80
Redline Communications .....solving the first mile challenge