Redline AN-30 System User Manual page 41

103-Parameters saved successfully!
104-Upgrade OK!
105-Password changed successfully!
106-Firmware programmed OK!
107-Statistics initialized!
108-Version control loaded successfully!
109-Options Key activated!
110-Options Key already used!
111-SNMP configuration loaded
successfully!
201-EEPROM corrupted. Def. param.
loaded!
202-Error while saving parameters!
203-Another upgrade in progress!
204-Invalid upgrade parameters!
205-Upgrade failed!
206-Password changed unsuccessfully!
207-Timeout on reading data packet!
209-TFTP error received!
210-Error: TFTP unknown message!
211-Error: while writing flash!
212-Error firmware configuration!
213-Firmware programming failed!
214-Error while loading version control!
215-Log buffer full!
216-Invalid Options Key!
217- PLL unlocked!
218-Outdoor unit over temperature!
219-Excessive DC loss on IF cable!
220-Outdoor unit power supply fault!
221-\public\ community can't be deleted!
222-Max.community number already
Redline Communications
AN-30 System User Manual
The latest configuration parameters have been successfully
saved into the system memory.
The software upgrade process completed successfully.
The system password was successfully changed.
The firmware was successfully programmed.
Reset of statistics was successful.
Software version control data was successfully loaded.
Product Options Key was accepted.
The Product Options Key was not accepted because it was
already used once. Contact your local Redline representative.
The SNMP configuration was successfully loaded.
The memory area containing the system configuration has been
corrupted. Default parameters loaded.
The latest configuration parameters have not been successfully
saved. In this case, repeat the save configuration process to try
to resolve the problem.
The system is already in upgrade mode, in the event the operator
inadvertently invoked multiple simultaneous upgrades.
The parameter entered is in error. If this message appears, check
for typing errors.
The software upgrade process completed unsuccessfully.
The new password entered into the system was not successful.
In this case, repeat the process.
The system has timeout looking for packets from the host
computer or server. Check for obvious problems such as
disconnected or faulty cable.
The Trivial File Transfer Protocol (TFTP) routine used to
download the software to the AN-30 terminal during the
Upgrade process failed. Likely cause is disconnected or faulty
cable.
The TFTP client received an unknown message. In this case,
repeat the upgrade process.
While writing the new software into AN-30 terminal flash
memory an unexpected error occurred. Try to repeat the process
and if the error persist contact your local Redline representative.
An unexpected error occurred while writing the onboard
firmware configuration. Try to repeat the process.
The firmware programming failed.
Software version control data was not loaded successfully.
The log buffer overflowed.
User entered an invalid Product Options key.
One or more RF synthesizers unlocked. The unit stopped RF
transmissions and attempted to reprogram the synthesizers. If
this message repeats or if the RF link is not back on, try to reset
the terminal. If the problem persists, contact customer support.
The T-58 Transceiver's internal temperature rose above 185F /
85C. The transceiver will shut down for 30 seconds to allow
cooling.
The DC voltage at the transceiver (carried by the IF cable from
the AN-30 terminal) is lower than the required 24VDC. Check
the IF cable and connectors.
Indicates a fault in the transceiver's power supply. This error
could be due to a problem with the internal power supply, or
with the power source from the AN-30 terminal. If the
'Excessive DC loss on IF cable' error is also indicated, check the
IF cable and connectors. If not, the T-58 Transceiver will require
servicing.
The default 'Public' SNMP community cannot be deleted.
No more communities may be defined, as the maximum number
Page 41 of 80
.....solving the first mile challenge