Serial Interface Configuration Commands - Redline AN-30 System User Manual

• tdm showactivebundles
tdm showactivebundles, no params
This command is used to return the number of active bundles and list the Ids of those
bundles
9.7.

Serial interface configuration commands

Set/Get operations
The general set/get operation has the following syntax:
tdm set <command> <serial interface number> <parameter value>
tdm get <command> <serial interface number>
The get operation returns values from the running configuration. The set operation
applies to the temporary configuration. The changes made by set operation become
active only after the "tdm save" command is successfully executed.
In the following commands, the "serial interface number" (SN) parameter must be a
valid serial interface number (i.e.: for 4 T1/E1 valid values are 1, 2, 3, and 4), otherwise
the command will return non-ack.
The commands for serial interface configuration are:
• coding
• framing
• lbo
The second parameter for each command is valid only if used with the set operation,
as indicated below.
coding, params: SN, COD_IND
Defines the line coding type for the current serial interface on T1/E1 module.
COD_IND
0
1
2
framing, params: SN, FRM_IND
Defines the framing type of the current serial interface on T1/E1 module.
FRM_IND
0
1
Redline Communications
Definition
B8ZS
AMI
HDB3
Definition
ESF
D4
Page 52 of 80
AN-30 System User Manual
.....solving the first mile challenge