Redline AN-30 System User Manual page 32

llmod (Link Length Mode): Specifies if the link length is calculated automatically or
manually.
llmode <param>
where:
- off: the system is automatically calculating the link length
- on: the system expect the user to enter the link length
llmu (Link Length Measurements Units): Specifies the current measurements units
used for the link length.
llmu <param>
where:
- off: the system defaults to miles
- on: the system will use kilometers
ll (Link Length): Specifies the actual length path that the wave need to travel.
ll <param>
where the parameter will represent the distance in miles or kilometers
flowctrl (Flow Control Enable): Flow control is a feature that Ethernet devices use to
pause transmission of incoming packets. If a buffer on the Ethernet port is overrun, the
port transmits a special packet (pause frame) that requests remote ports to delay sending
packets for a period of time. For more information, see Appendix 2 – AN-30 Support For
TDM explained.
telnet (Telnet Enable): Telnet is used to connect to remote devices, usually via Telnet
port 23. Once a Telnet connection is established, it is possible to log in using the 'admin'
or 'user' user id and set the parameters of the unit using the CLI
telnetport (Telnet Port): The default Telnet port is 23. The port can be changed to any
other number between 23 and 65,000, excluding port 80.
set snmp (SNMP Enable / Disable): Specifies whether the Simple Network
Management Protocol (SNMP) agent is enabled. When this item is enabled, a listing of
the current SNMP communities and associated parameters can be viewed.
snmpcomm (Community Name): To add a new SNMP community:
snmpcomm add <community name> <access>
where <access> can be: "r","w","t" or any combination
To delete an SNMP community type: snmpcomm del <community name>
snmpaccess (Community Access): To modify access rights for a community type:
snmpaccess <community name> <access>
where <access> can be: "r","w","t" or any combination
- r (Read): use 'Read' to grant read access permission to members of this
community
Redline Communications
AN-30 System User Manual
Page 32 of 80
.....solving the first mile challenge