Redline AN-30 System User Manual page 51

If the idle code command is not specified, the default value 0xFF is used.
key, no params.
This is used only with a get operation: tdm get key
This command will get the option key (permitted line types, number of lines, user
data) on the T1/E1 module.
Bit7..5
1
Enable
unused
User
Port
line, params: LINE_TYPE
This command will set the line type on the T1/E1 module (if permitted by the option
key).
LINE_TYPE
0
1
softver, no params
This command is used only with a get operation. Represents the coded software
version.
fanstate, no params
This command will return 1 if the fan is ON (working) and return 0 if the fan is OFF
(not working).
Show Operations
The show operation is:
• tdm showgen
tdm showgen, params: CONFIG
This command is used to get the general configuration parameters from running or
startup config.
The default configuration selected is running config.
CFG
0
1
Redline Communications
KEY fields
Bit4 Bit3
-
1- Enable 1 -Enable
T1 line E1 line
type type
Definition
T1 line
E1 line
Definition
running config
startup config
Page 51 of 80
AN-30 System User Manual
Bit2 Bit1..0
00-1 line
01-2 lines
10-4 lines
11-reserved
.....solving the first mile challenge