Redline AN-30 System User Manual page 49

The general set/get operations have the following syntax:
tdm set <command> <parameter value>
tdm get <command>
The get operation returns values from running configuration, the set operation applies to
the temporary configuration. The changes made by set operation become active only after
the tdm save command is successfully executed.
The general command set is as follows:
hostname
ipaddr
ipmask
gateway
vlandata
vlanvoice
clock
syncon
idlecode
key
line
softver
fanstate
The parameter for each command is valid only if used with the set operation.
hostname, params: HOST
The hostname of the T1/E1 module.
ipaddr, params: IP address in format a.b.c.d
The IP address of the T1/E1 module.
The TDM module in the AN-30 is uniquely identified by its IP address. The IP
address is used with the destip command to direct TDM traffic to a specific AN-30
end point.
By uniquely addressing the TDM module within the AN-30 it is possible to relay
traffic through an intermediate set of AN-30s without terminating the TDM stream.
The intermediate AN-30s can therefore act as a repeater while also providing Add
Drop Multiplexing (ADM) functionality as shown in Figure 16.
ipmask, params: IP mask in format a.b.c.d
The network mask. Not implemented for tdm_set operation
Redline Communications
Set/Get Operations
Page 49 of 80
.....solving the first mile challenge
AN-30 System User Manual