Table of Contents
Advertisement
2
.
I
m
p
o
r
t
a
n
t
S
2
.
I
m
p
o
r
t
a
n
t
S
1
Read this User Manual and follow all operating and safety instructions.
2
Keep all product information for future reference.
3
This product is supplied with a grounding power plug. Do not defeat this
important safety feature.
4
The power requirements are indicated on the product-marking label. Do not
exceed the described limits.
5
Always replace the fuse with the correct type and current rating.
6
Position the power cord to avoid possible damage, and do not overload wall
outlets.
7
Do not place this product on or near a direct heat source, and avoid placing
objects on the terminal.
8
Do not operate this device near water or in a wet location.
9
Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners.
Disconnect the power before cleaning.
10
Protect the unit by disconnecting the power if it is not used for long periods of
time.
11
Locate the AN-30 terminal on a stable horizontal surface or mount it securely in a
19" Telco rack.
12
The T-58 Transceiver unit must not be located near power lines or other electrical
power circuits.
13
The T-58 Transceiver must be properly grounded to protect against power surges
and accumulated static electricity. It is the user's responsibility to install this device in
accordance with Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984
or Section 54 of the Canadian Electrical Code. These codes describe correct installation
procedures for grounding of the transceiver unit, mast, lead-in wire and discharge unit,
location of discharge unit, size of grounding conductors and connection requirements for
grounding electrodes. It is recommended that the installation of the transceiver be
contracted to a professional installer.
Redline Communications
a
f
e
t
y
I
n
f
o
r
m
a
t
i
o
n
a
f
e
t
y
I
n
f
o
r
m
a
t
i
o
n
Page 10 of 80
AN-30 System User Manual
.....solving the first mile challenge
Advertisement
Table of Contents
