Ds0 Bundle Configuration Commands - Redline AN-30 System User Manual

2
3
4
lbo, params: SN, LBO_IND
Defines the LBO parameter of the current serial interface on T1/E1 module.
This command has effect only on T1 modules.
LBO_IND
0
1
2
3
Show operations
The show operation is:
• tdm showserial
tdm showserial, params: SN, CFG
This command is used to get the serial interface parameters pointed by SN from running
or startup config.
If the CFG parameter is not specified the running config is selected by default.
CFG
0
1
9.8.

DS0 Bundle configuration commands

A DS0 bundle is a logical mapping of a number of timeslots from the same physical
T1/E1 port.
The starting timeslot selected (ts_begin) is:
ts_begin = 0 if the line is unframed. In this case the number of selected ts must be 32 for
E1 or 24+1 for T1.
1<= ts_begin<=31(24 for T1) and tsnumber<=32-ts_begin (<=24+1-ts_begin for T1)
for framed. In this case the number of selected ts must be less than or equal to 31-
ts_begin (24 - ts_begin for T1). If multiple DS0 bundles are defined for the same line,
they must not overlap. So valid value will be:
for E1 ts_begin=1, ts_num=31
for T1 ts_begin=1, ts_num=24
Redline Communications
CRC4
FAS
unframed
Definition
0dB
-7.5dB
-15dB
-22.5dB
Definition
running config
startup config
Page 53 of 80
AN-30 System User Manual
.....solving the first mile challenge