Cli System Configuration Commands - Redline AN-30 System User Manual

AN-30 System User Manual
show config (List Configuration): Returns a list of all System Configuration
parameters.
show log (List the log file): Returns a list of current system log entries.
show snmp (List SNMP Configuration): Returns a list of all SNMP communities and
related parameters.
show stats (List System Status): Returns a list of all System Status parameters.
test config (Test System Configuration): Allows testing of configuration settings for 5
minutes, after which the system reverts to the previously saved settings. To make settings
permanent use 'save' command.
upgrade (Software Upgrade): Begin a software upload.
upgrade <ipaddr> <filename>
8.2.

CLI System Configuration Commands

To store the parameters into memory, the CLI Save Configuration command must be
used. This operation is recorded in the System Logs.
sysname (System Name): An alphanumeric identifier for the local terminal, which can
consist of any combination of letters and numbers up to 20 characters in length. The
default name for the system from the factory is set to WEB01. The name remains with
the system, even during power off states, until the operator re-types a new name using
this menu field.
sysdetails (System Details): Specifies the location of the unit, telephone number and/or
contact information of the network administrator. Can be up to 20 characters in length.
ipaddr (IP address): This field is used to provide an IP address for the local AN-30
terminal. The default address from the factory is 192.168.25.2. For the initial setup, the
terminal should not be connected to the Internet, i.e., the host computer should be
connected directly to the terminal Ethernet port, to avoid address conflicts with other
devices on a public network. Once an IP address has been set, the terminal can be
connected to the core network.
ipmask (IP Subnet Mask): This field is used to set the desired IP subnet mask. The
mask value is set to "255.255.255.0" (Class C subnet).
gateway (Default Gateway Address): Specifies the IP address of the default router /
gateway on the local Ethernet segment.
Page 31 of 80
Redline Communications .....solving the first mile challenge