Table of Contents
Advertisement
AN-30 System User Manual
5
.
T
h
e
A
N
-
3
0
T
e
r
m
i
n
a
l
a
t
a
G
l
a
n
c
e
5
.
T
h
e
A
N
-
3
0
T
e
r
m
i
n
a
l
a
t
a
G
l
a
n
c
e
The front panel of the AN-30 terminal includes an RJ45 Ethernet interface, four (4) RJ48
/ BNC E1/T1 interfaces and four (4) grouped status indicators; System, Wireless, TDM
and Ethernet. The rear of the terminal includes the power cord connector and an F-Type
female connector for the IF cable.
At power up, an LED power-up sequence occurs as follows:
All three Ethernet LEDs light for one second, then individual Ethernet LEDs blink twice
in the following order: 100, FD, Link. The Fault LED lights for approximately four
seconds, then turns off. The two Wireless LEDs remain off for approximately five
seconds, then blink once and resume their normal state.
A) System Status Indicators
The System portion of the front panel features a recessed reset switch and two LEDs
(Pwr and Fault), as shown in the figure below.
Figure 2: Front Panel – System
Reset – The system can be manually hard reset by depressing the "Reset" button recessed
in the front panel. The reset button is used to reactivate the terminal in the event that it is
functioning improperly or is in a state of suspension.
Pwr – The "Pwr" LED lights solid green when the AC power is properly applied to the
terminal. In the event of internal power supply failure, if the cord is disconnected, or if
the fuse is blown, the "Pwr" light will not illuminate.
Fault – The "Fault" LED lights solid red when a serious fault is detected within the
system.
B) Wireless Status Indicators
The Wireless portion of the front panel features two LEDs; Link and Signal, as shown
below.
Page 14 of 80
Redline Communications
.....solving the first mile challenge
Advertisement
Table of Contents
