Redline AN-30 System User Manual page 37

Table of Contents

Advertisement

23
24
25
26
27
28
29
30
31
Error Details:
AN-30 PLL Error: The PLL (Phase Locked Loop) section within the AN-30 terminal
experienced an error. The System Fault LED may light. Try resetting the unit.
Communication Error Over IF Cable: Communication between the AN-30 terminal and
the T-58 Transceiver failed. Check the IF cable and connectors.
Radio High Temp. Warning: The T-58 Transceiver's internal temperature rose above 185F
/ 85C. The transceiver will shut down for 30 seconds to allow cooling time.
Radio Power Supply Fault: Indicates a fault in the transceiver's power supply. This error
could be due to a problem with the internal power supply, or with the power source from the
AN-30 terminal. If the Low DC Voltage At Radio error is also indicated, (see below) check
the IF cable and connectors. If the Low DC Voltage At Radio error is not indicated, the T-58
Transceiver will require servicing.
Low DC Voltage At Radio Input: The DC voltage at the transceiver (carried by the IF
cable from the AN-30 terminal) is lower than the required 24VDC. Check the IF cable and
connectors. The minimum required voltage for operation is 12VDC.
Ethernet LAN Statistics:
erxpkt (Rx packets): Counts the number of packets successfully received by the local
system.
erxpktd (Rx packets – Discarded): Counts the number of packet errors received by the
local system.
etxpkt (Tx Packets): Counts the number of Ethernet packets transmitted by the local system.
Wireless Statistics:
rssimin (Received Signal Strength – Min): Indicates the minimum received signal strength
measured since the last screen refresh.
Redline Communications
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Page 37 of 80
AN-30 System User Manual
X
X
X
X
X
X
X
X
X
X
.....solving the first mile challenge
X
X
X
X
X

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AN-30 System and is the answer not in the manual?

Table of Contents