Configuration; Control Commands - Redline AN-30 System User Manual

9.4.

Configuration

The AN30 maintains 3 TDM configuration images,
• Temporary Configuration
• Running Configuration
• Startup Configuration
Through these distinct images the actions of
modifying the temporary configuration, and
activating a modified configuration are separated. T
operator can therefore make all changes in advan
the actual cut over without impacting the unit's
current operation.
The following sections describe the complete T1/E1 command set and their associated
parameters.
9.5.

Control commands

The control commands are used to manipulate the contents of each of the configuration
images as well as to save and activate, a specific configuration. There are 4 control
commands:
• tdm start
• tdm exit
• tdm save
• tdm copy
tdm start, no params.
This command synchronizes the temporary configuration with the running configuration.
Before making any changes to the temporary configuration you must first issue the tdm
start command to copy the running configuration into the temporary configuration
image.
tdm exit, no params.
This command discards all changes made to the temporary configuration.
Clearing the temporary configuration avoids the possibility of inadvertently loading a
modified configuration in the event that a tdm save command being accidentally issued.
This command should always be issued to leave the temporary configuration image
synchronized with the running configuration.
Redline Communications
AN-30 System User Manual
tdm_start tdm_start
he
ce of
Page 46 of 80
.....solving the first mile challenge
Temporary Temporary
Configuration Configuration
tdm_save tdm_save
Running Running
Configuration Configuration
tdm_copy tdm_copy
Startup Startup
Configuration Configuration