Download Print this page

General Configuration Commands - Redline AN-30 System User Manual

Hide thumbs

Table Of Contents

Table of Contents

Error codes are described in the following table:

Error Code

0:0:1

Too many bundles: if user defines more than the internal bundle

limit for the current software release

0:0:2

Line type (T1 or E1) is disabled in option key

0:0:3

Error at "syncon" parameter: if clocking is "loopback" and the

serial interface selected for synchronization has no bundles

defined, or if clocking is "adaptive" and there is no exactly one

bundle defined

1:x:0

Bundles defined on the serial line "x" have timeslots overlapping,

x=1...4

1:x:1

The serial line "x" is unframed and the user defined more than one

bundle, x=1...4

1:x:2

Wrong line coding for the serial line "x", x=1...4

1:x:3

Wrong line framing for the serial line "x", x=1...4

2:y:0

The bundle "y" contains timeslot 0 and the corresponding serial

line is framed, y=1...128

2:y:1

Too many timeslots selected for bundle "y", y=1...128

tdm copy, no params

This command copies the current running configuration into the Startup configuration.

A running configuration is stored in volatile memory and will be lost in the event of a

system reset.

Therefore, once you are satisfied with a new configuration, the tdm copy command must

be issued to store the new configuration into the Startup Image. This is the only way to

permanently save an operating configuration. In order to insure the integrity of the saved

image all real-time tasks are halted during execution of the tdm_copy command.

Warning:

This command will reset operation of a working AN-30 link disrupting all

communications while the unit re-initializes to the new configuration. On a production

network this command should only be issued during the off hours of a maintenance

window.

Each time the unit is powered it will automatically load the last configuration that was

copied to the Startup Image.

9.6.