Table of Contents
Advertisement
BTS Site B
BTS Site B
9.2.
Command Line Interface
The command line interface is used to configure the T1/E1 capabilities via the AN-30's
console port or through a telnet session. The command set is divided into 5 categories,
Control, General, Serial Interface, DS0 Bundle, and Statistics. The General, Serial
Interface and DS0 Bundle categories supports 3 distinct operations, a get operation, a set
operation and a show operation.
The tdm get operation is used to retrieve the specified parameter value from a running
configuration of an active system.
The tdm set operation is used to modify the specified parameter value in the temporary
configuration.
The tdm show<category> operation is used to list all parameter values of the specified
command category for either the running configuration or the startup configuration.
All commands conform to the following syntax:
<command operation> <command> <command target> <parameter value>
The <command target> field, is only used by the Serial Interface and DS0 Bundle
category of commands:
The <parameter value> field is only required when issuing a tdm set operation.
Redline Communications
AN-30T
AN-30T
AN-50
AN-50
Figure 16 Typical PTP 'multi-hop' configuration
Page 44 of 80
AN-30 System User Manual
Base Station Controller Site
Base Station Controller Site
AN-30T
AN-30T
BTS Site A
BTS Site A
AN-30T
AN-30T
.....solving the first mile challenge
Advertisement
Table of Contents
