Ntp Peers: Adding, Configuring, Removing - Spectracom PRISMA VelaSync User Manual

2.10 Configuring NTP
2.10.8.3 NTP Peers: Adding, Configuring, Removing
To add, configure, or remove an NTP Peer:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup .
2.
The NTP Setup screen appears. The NTP Peers panel displays a list of recognized NTP
peers.
3.
The NTP Peers edit window opens:
4.
Enter the required information into the fields:
74
Note: Should the list be empty, no servers have been added yet. In the
event that added peers are not displayed, they could not be resolved.
Verify the IP address
To the settings of an NTP Peer, click the GEAR button next to it, and proceed
EDIT
to Step 3 below.
To ADD a new NTP Peer, click the PLUS icon in the top right corner of the NTP
Peers panel.
To REMOVE an NTP Peer (and its associated configurations), click the X-button
next to it.
Host : The IP address for the server to be used as host.
Min Poll Interval : Select a value from the drop down (the default is 3 (8s).
Max Poll Interval : Select a value from the drop down (the default is 3 (8s).
For both NTP Peers, and NTP Servers the Minimum and Maximum Poll rate for
NTP packets can be configured.
CHAPTER •
2 VelaSync User's Manual Rev. 1