Skipping The Countdown Time; Setting Measurement Intervals - Microlife WatchBP Office Central Instruction Manual
Cardiovascular screening solution for central blood pressure measurement, ankle brachial index assessment, atrial fibrillation detection, simultaneous assessment of the inter-arm, blood pressure difference
Table of Contents
Advertisement
Taking measurements using WatchBP Office Central (cont.)
Skipping the countdown time
The 60 seconds countdown before measurement in
«SCREEN» Mode and 15 seconds in «CENTRAL» Mode
can be skipped by pressing the Start/Stop Button.
While the Start/Stop Button is pressed, the device
will immediately begin the next measurement.
Skip the countdown time
and begin measurement.
The device can be set into Standby Mode by pressing
*
the Start/Stop Button after the completion of
measurements. The device will automatically switch to
Standby Mode if left unattended for five minutes.
20
Standby Mode
Setting measuring intervals in «CENTRAL»
Mode
1) Pressing and holding the Start/Stop Button for 3
seconds.
2) Press the M Button to adjust the measurement
interval, then press the Start/Stop Button to
confirm, the device will go back to Standby
Mode.
15 30
60
45
The default measuring interval is 15 seconds. The
*
interval can be set as 15, 30, 45 or 60 seconds.
Press and hold
for 3 seconds...
Advertisement
Table of Contents
