Skipping the countdown time
The 60 seconds countdown before measurement in
«SCREEN» Mode and 15 seconds in «ROUTINE» Mode
can be skipped by pushing the Start/Stop Button.
While the Start/Stop Button is pushed, the device will
immediately begin the next measurement.
Skip the countdown time
and begin measurement.
The device can be set into Stand-by Mode by pressing
*
the Start/Stop Button after the completion of
measurements. The device will automatically switch to
Stand-by Mode if left unattended for five minutes.
Stand by mode
Taking less than three measurements
The measurement sequence can be stopped at
anytime by pushing the Start/Stop Button in
«SCREEN» or «ROUTINE» Mode. The device enters
stand-by and the remaining measurements are
cancelled. Average of the measurements is saved
and can be viewed by pushing the M Button.
Cancel remaining
measurements at
anytime during
the measurement
sequence.
21
EN