Hantek DSO3062L User Manual page 80

Generate the Ramp waveform
To output a Ramp Wave, please do the following steps:
1. Press the check box "On/Off" to open the wave output function.
2. Select the Wave Type "Ramp".
3. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Phase: Set the output wave phase.
Duty: The duty of the output wave.
The Ramp waveform window as the following:
Generate the Trapezia waveform
To output a Trapezia wave, please do the following steps:
1. Press the check box "On/Off" to open the wave output function.
2. Select the Wave Type "Trapezia".
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set output wave vertical level offset.
Phase: Set the output wave phase.
Duty: Set the output wave duty.
Rise Duty: Set the output wave rise duty.
High Duty: Set the output wave high duty.
Fall Duty: Set the output wave fall duty.
USER'S MANUAL
DSO3062L/DSO3062AL
Digital Oscilloscope
78