The User's Interface - Hantek DSO3062L User Manual

2.1 The User's Interface

Click the software icon on the desk after you finished the software setting and equipment
connecting. Then a user interface will be showed as follows:
In addition to displaying waveforms, the display area is filled with many details about the
waveform and the oscilloscope control settings.
1.The Main Menu
All settings can be found in the main menu.
2.The Toolbar
3.Displays the trigger information
Displays the edge trigger slope, source and level.
4.The DDS Panel (DSO3062AL)
5.The Horizontal Panel
The user can change Time/Div, format in the panel.
6.The Vertical Panel
The user can turn on/off the CH1/CH2. Also the user can change the CH1/ CH2 volt/div,
coupling and probe attenuation.
7.The LA Panel
In this panel, the user can set the LA voltage value.
8.The Trigger Panel
In this panel, the user can change the trigger mode, sweep, source and slope.
9.Displays the system time.
USER'S MANUAL
DSO3062L/DSO3062AL
Digital Oscilloscope
17