Hantek DSO3062L User Manual page 39

Source:
PW Condition:
Pulse Width: The Pulse Width adjust range is 10ns~10s. When the condition is met, it will
trigger and acquire the waveform.
The user can also change the trigger setting on trigger panel in sidebar.
When alternative trigger is on, the trigger sources come from two vertical channels. This
mode can be used to observe two non-related signals. You can choose two different trigger
modes for the four vertical channels.
Options Settings
Pulse
Auto,
Sweep Normal,
Single
CH1
Source CH2
EXT
+Less,
+Equal,
PW +More
Condition -Less
-Equal
-More
Pulse Width
USER'S MANUAL
Comments
With Pulse highlighted, the trigger occurs on pulses that
meet the trigger condition (defined by the Source, When
and Set Pulse Width options).
Auto: Acquire waveform even no trigger occurred
Normal: Acquire waveform when trigger occurred
Single: Acquire waveform when trigger occurred then stop.
Select the input source as the trigger signal.
+Less: +Pulse width less than selecting pulse condition.
+Equal: +Pulse width equal than selecting pulse condition.
+More: +Pulse width more than selecting pulse condition.
-Less: -Pulse width less than selecting pulse condition.
-Equal: -Pulse width equal than selecting pulse condition.
-More: -Pulse width more than selecting pulse condition.
Set Pulse Width highlighted, including Time Unit and
Pulse Width
DSO3062L/DSO3062AL
Digital Oscilloscope
37