Hantek DSO3062L User Manual page 78

Waveform Parameter Setup
Select a wave type, and you can set the "Parameters" in the sidebar.
Generate the Sine waveform
To output a Sine Wave, please do the following steps:
1. Press the check box "On/Off" to open the wave output function.
2. Select the Wave Type "Sine Wave".
3. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Sweep: Set the output wave to sweep.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Phase: Set the output wave phase.
The Sine waveform window as the following:
Generate the Square waveform
To output a Square Wave, please do the following Step:
1. Press the check box "On/Off" to open the wave output function.
2. Select the Wave Type "Square".
3. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Phase: Set the output wave phase.
Duty: Set the duty of the output wave.
USER'S MANUAL
DSO3062L/DSO3062AL
Digital Oscilloscope
76