Hantek DSO3062L User Manual page 31

DSO3062L/DSO3062AL
Digital Oscilloscope
Set Channel Coupling
Click "Coupling" in "Vertical Setup" window
.
In the sidebar, you can change the channel coupling too
You can set the coupling to DC, AC or GND. If you set the coupling to DC, it blocks the AC
component of the input signal.
Probe Attenuation Setting
Select the attenuation factor for the probe. To check the probe attenuation setting, toggle
the probe menu to match the attenuation factor of the probe.
This setting remains in effect before you changed again.
Click "Probe" in Vertical Setup window to select the probe attenuation
The probe setting window in the sidebar
Note: The attenuation factor changes the vertical scale of the oscilloscope so that the
measurement results refect the actual voltage levels at the probe tip.
USER'S MANUAL 29