Primex XR 5 Watt Install & Operation Manual page 5

Important Safety Instructions
READ ALL INSTRUCTIONS BEFORE INSTALLATION, OPERATION, OR MAINTENANCE OF PRODUCT.
Some of the following information may not apply to your particular product model; however, as with any electronic product,
precautions should be observed during installation, operation, and maintenance.
Never operate the Transmitter without the antenna being properly connected to the Transmitter. Operating the Transmitter
l
without an antenna can lead to permanent damage of the Transmitter and poses a safety risk.
Do not touch any of the antennas while broadcasting, as it could result in a skin burn or other injuries.
l
Standard acceptance procedures must be followed prior to operating this equipment in the proximity of life support systems.
l
Do not operate the Transmitter outdoors, in wet areas were there is standing water, or in areas where there is condensation or the
l
risk of condensation. Use in any of these environments will damage the Transmitter and void the warranty.
Do not open the Transmitter to alter the internal elements in any way. This will void the warranty and could lead to unsafe
l
conditions, malfunction, and violations of FCC/IC regulations.
Do not use a metal ladder during installation of the external antenna.
l
During antenna installation, be sure to wear shoes with rubber soles and heals and wear protective clothing with long sleeves
l
and rubber gloves.
Do not install the antenna on a wet or windy day when lighting or thunder is in the area or near power lines. Power lines,
l
telephone lines, and guy wires look the same. As a precaution please assume any wire can electrocute you.
The installation, maintenance, or removal of an antenna requires qualified, experienced personnel. The installation instructions are
written for such installation personnel.
Antenna systems should be inspected once a year by qualified personnel to verify proper installation, maintenance, and condition
of equipment.
Primex disclaims any liability or responsibility for the results of improper or unsafe installation practices.
Equipment Precautions
Radio Frequency (RF) Exposure
To comply with FCC OET65 and Industry Canada RF exposure requirements, the antenna is only to be used or installed in locations
where the following antenna separation guidelines (distance above roofline) exist when the Transmitter is in operation.
Transmitter (Power Level)
5 Watt
30 Watt
Healthcare Facility - Installation, Location, Conditions, Inspection
If the system is installed in a healthcare facility, top-floor testing must be performed to verify the power level IS LESS THAN -15dBm
and that no external antenna is be placed within 30 ft. (9.1 m) of any window or other GLASS CEILING or WINDOW of the facility.
Distance Above Roofline (direct line of sight only)
6.8 ft. (2.0 m)
9.3 ft. (2.8 m)
5