Primex XR 5 Watt Install & Operation Manual page 26

4. Connect the two long frames rails by placing the two short frame rails on top of the four protruding bolts to form a rectangle.
Make sure the square holes in the short tail "sides" are directly opposite each other.
5. Place a washer and nut on each of the four bolts and finger tighten.
6. Position the tripod within the four-sided frame.
7. Secure the three tripod legs to the inside of the frame by inserting three short bolts, from the inside and placing the washer
and nut on the outside of the frame.
8. Drop the bottom of the mast (end with hole) through the top of the tripod collar.
9. Place the remaining two short rails parallel to each other, separated by the bottom of the mast.
10. Align the hole at the bottom of the mast, with the two square holes in the short frame rail sides.
11. Insert the long bolt and connect the frame rails to the mast.
12. From the underside of the frame, insert the four remaining short bolts upward and connect the inner short tails to the frame.
13. Tighten all nuts to secure.
14. Use six 8 inch x 8 inch x 16 inch concrete blocks to ballast the antenna mounting. Blocks are to be placed from rail to rail on
each side of the mast; three blocks per side with a single block placed on each end and one in the middle.
26
XR 5 Watt & 30 Watt Transmitter Install & Operation Guide