Table of Contents
Advertisement
Assemble Non-Penetrating Roof Mount Kit Mount
The Non-Penetrating Antenna Kit is designed for mounting a ground plane omnidirectional antenna when mounting to the side
of a structure is not practical. The overall footprint of the frame is 29 inches x 35 ½ inches (73.66 cm x 88.9 cm).
Kit Contents
NOTE
Installation requires six 8 inch x 8 inch x 16 inch concrete blocks (not supplied).
The kit is supplied with the following parts. If any of these items are missing, please contact Primex.
Rigid galvanized conduit mast | 5 ft. x 1.25 inches (1.52 m x 3.17 cm)
Tripod leg | 27 inches (2.54 cm) each in length
Frame rail (long) | 34 ¾ inches (88.26 cm)
Frame rail (short) | 28 ¼ inches (71.75 cm)
Grounding Clamp
Long carriage bolt
Short carriage bolt
Flat washers
Lock nuts
How to assemble a Non-Penetrating Antenna Mount
1. Verify the kit contents.
2. Assemble the outer frame by laying the two long frame rails parallel to each - approximately 30 inches (76.2 cm) apart.
3. Insert a short carriage bolt from the bottom at each frame rail end, pointing skyward (4 total).
Description
Qty
1
3
2
4
1
1
11
12
12
25
Advertisement
Table of Contents
