Table of Contents
Advertisement
Install Antenna Pole Mount Kit
The Antenna Pole Mount kit is designed for the purpose of mounting the antenna to round or angled tower legs.
The clamps can be used on round tower legs that measure from 1.25 inches to 3.25 inches (3.17 cm to 8.25 cm) OD or on
l
angled tower legs that measure up to 3 in. (7.62 cm) on a side.
The center section of each clamp is welded to provide mechanical stability and all parts are hot-depped galvanized steel.
l
Kit contents
The kit is supplied with the following parts. If any of these items are missing, please contact Primex.
Description
Rigid galvanized conduit section | 5 ft. by 1.25 inches
Rigid galvanized conduit section | 5 ft. by 1 inches
X style clamp
U-clamp
1/2 inch all thread bolt
1/2 inch lock washer
1/2 inch hex nut
How to mount an antenna using a Pole Mount Antenna Kit
1. Verify the kit contents.
2. Assemble both clamps, tightening the hex nuts to an approximate torque of approximately 45 ft-lbs.
3. Tighten half of one clamp two feet below the top of the pole. Use a 3/4 inch wrench to do this and be sure to tighten the
clamps both evenly and securely.
4. Using a 3/4 inch wrench, tighten half of the other clamp a few in. below the top of the pole. Be sure to tighten the clamps
both evenly and securely.
5. Connect the LMR 400 cable to the antenna. Be sure the connection is tight.
6. Insert the mast into the clamps. The bottom of the mast should be a minimum of 2 inches below the bottom clamp.
Qty
1
1
2
4
4
16
16
31
Advertisement
Table of Contents
