Install Penetrating Antenna Kit
The Penetrating Antenna Kit contains the materials required to mount the antenna to a wooden pole or masonry wall. A 5/8 inch
(1.58 cm) diameter mounting hole is required and the maximum diameter of the pole or wall thickness is 14 inches (35.56 cm).
Kit contents
The kit is supplied with the following parts. If any of these items are missing, please contact Primex.
Description
Rigid galvanized conduit section | 5 ft. x 1.25 inches
Rigid galvanized conduit insert | 5 ft. x 1 inch
Antenna mounting clamp
Hex head bolt | 1/2 inch
Bolt washer | 1/2 inch
Lock washer | 1/2 inch
Hex nut | 1/2 inch
How to mount an antenna using a Penetrating Antenna Kit
NOTE
The recommended diameter of the pole or the wall thickness should not exceed 14 inches (35.56 cm).
1. Verify the kit contents.
2. Assemble both clamps, as shown below, tightening the hex nuts to a torque of approximately 45 ft-lbs.
28
Qty
1
1
2
2
8
8
8
XR 5 Watt & 30 Watt Transmitter Install & Operation Guide