Primex XR Quick Install Manual

XR T S
IME YNCHORNIZATION
UK 1/2 W T
ATT RANSMITTER
The purpose of this guide is to provide an overview of the XR Transmitter 1 Watt - Internal Antenna installation instructions. Prior to
installation, it is strongly recommended to review the XR Transmitter 1 Watt - Internal Antenna Installation and User Guide for
detailed installation procedures.
System Components
1 Watt Transmitter - Internal Antenna Model
Transmitter
l
Power supply
l
Optional Equipment
GPS Receiver
l
GPS Extension Cable
l
GPS Receiver Mounting Kit
l
Satellite Transmitter
l
1-Watt Transmitter Rack (18 GA metal, epoxy coated)
l
Surge Protector and Battery Back-up system
l
I
MPORTANT
READ ALL INSTRUCTIONS BEFORE INSTALLATION, OPERATION, OR MAINTENANCE OF PRODUCT.
Some of the following information may not apply to your particular product model; however, as with any electronic product,
precautions should be observed during installation, operation, and maintenance.
Never operate the transmitter without the antenna being properly connected to the transmitter. Operating the
l
transmitter without an antenna can lead to permanent damage of the transmitter and poses a safety risk.
Do not touch any of the antennas while broadcasting.
l
Standard acceptance procedures must be followed prior to operating this equipment in the proximity of life support
l
systems.
Do not operate the transmitter outdoors, in wet areas were there is standing water, or in areas where there is
l
condensation or the risk of condensation. Use in any of these environments will damage the transmitter and void the
warranty.
Do not open the transmitter to alter the internal elements in any way. This will void the warranty and could lead to
l
unsafe conditions, malfunction, and violations of regulations.
Primex Wireless disclaims any liability or responsibility for the results of improper or unsafe installation practices.
Installation and Configuration Overview
Review the Installation Guidelines and identify the installation location of the transmitter and system components.
l
additional information, see "Transmitter Installation Location Guidelines" located on page 2.
Doc Part No.: XRK023 08.27.14
- I
NTERNAL
S I
AFETY NSTRUCTIONS
A Q I
NTENNA UICK NSTALL
G
UIDE
For