Primex XR 5 Watt Install & Operation Manual page 41

How to configure a Transmitter to use a NTP time source
1. Located on the back of the Transmitter, set dip switch 1 and 2 to the UP position.
2. Insert one end of an Ethernet cable into the Ethernet port located on the back of the Transmitter and the other end into a port
on the facility's Ethernet network.
3. Apply power to the Transmitter.
4. From your computer, open a web browser and from the address bar enter the Transmitter's factory default IP address:
http://192.168.1.1
If the Transmitter IP address has been changed from the factory default address, complete the steps in topic
Temporary IP Address for the Transmitter LAN Interface.
NOTE
Your computer is required to be on the same subnet as the Transmitter (for example: 192.168.1.10).
5. The Connect To dialog window is displayed.
6. Leave both user name and password blank, click OK to log into the Transmitter. The XPort Device Configuration Manager
screen is displayed.
Set a
41