Validating Network Discovery; Installing Matrox Extio Central Manager Software - Matrox Extio N3408 User Manual

Validating network discovery

Extio 3 devices are initially assigned their IP addresses through DHCP (Dynamic Host Control
Protocol). After connecting your devices, we recommend verifying that all of your devices are
discovered by the network.
Windows 10/7 – To make sure all of your devices are discovered by the network:
Windows 10 – Click
all the Extio 3 devices connected are listed.
Windows 7 – Click
Devices
If prompted to enable network discovery and file sharing on your network when validating network
discovery, enable these two features by clicking on the prompt at the top of your Windows Explorer
window. These two features must be enabled for Extio Central Manager software to detect the Extio 3
devices.

Installing Matrox Extio Central Manager software

Matrox Extio Central Manager software enables you to remotely manage, monitor,
and configure your networked Extio 3 devices.
Supported operating systems
Matrox Extio Central Manager supports the following operating systems: Windows® Server® 2016,
Windows® 10 (64-bit), Windows® Server 2012 R2, Windows® Server® 2008 R2, and Windows® 7.
Obtaining Matrox Extio Central Manager software
To obtain the latest Extio Central Manager software, contact your Matrox representative. Matrox
makes the latest Extio Central Manager software available on the Matrox web site
(www.matrox.com/graphics/extio3sw).
Installing Matrox Extio Central Manager software
To install the software for your Extio 3 product, run the installation program for your software
package on any system on the network. Follow the on-screen instructions.
Note: Only one (1) instance of Extio Central Manager software needs to be installed.
Start File Explorer
Start Acessories
, make sure all the Extio 3 devices connected are listed.
. Under
Network Other Devices
Windows Explorer Network
Matrox Extio 3 Series – User Guide 33
, make sure
. Under
Other