Getting Started; Networked Mode; Point-To-Point Mode - Matrox Extio N3408 User Manual

Getting started

The following outlines the steps for installing, connecting, and setting up your Extio 3 device.

Networked mode

In networked mode, Extio 3 devices operate over a copper-based or fiber-based Gigabit Ethernet
network.
Install your card –
1
2 Connect your devices –
Validate your setup –
3
4 Update your firmware –
Validate your network discovery –
5
6 Install your Extio Central Manager software –
Manager software", page
Configure your Extio devices through Extio Central Manager software – For more
7
information on using Extio Central Manager software, see the Matrox Extio Central
Manager User Guide.
Log into your receiver and switch to different transmitters (OSD) –
8
(On-Screen Display)", page

Point-to-point mode

In point-to-point mode, Extio 3 transmitter and receiver devices are directly linked to each other
using copper or fiber optic cable.
Install your card –
1
2 Connect your device –
Update your firmware –
3
4 Enable point-to-point mode –
"Setting up point-to-point mode", page
Configure your Extio devices –
5
10 Matrox Extio 3 Series – User Guide
see "Installing your Extio 3 transmitter card", page
see "Connecting your Extio 3 devices", page
see "Validating your Extio 3 setup", page
see "Updating your Extio 3 firmware", page
see "Validating your Extio 3 setup", page
37.
34.
see "Installing your Extio 3 transmitter card", page
see "Connecting your Extio 3 devices", page
see "Updating your Extio 3 firmware", page
see "Using the OSD (On-Screen Display)", page 38
37.
see "Configuring your Extio devices", page
14.
18.
28.
see "Installing Matrox Extio Central
see "Using the OSD
14.
28.
11.
18.
11.
and
39.