Terminal Block - Thermo Scientific 60i Quick Start Manual

Optional 4-20mA Current Outputs
and Analog Voltage Inputs
62i Probe Control
(optional)
RS-232/485
Ethernet
Standard I/O
AC Power
Making Data and
I/O Connections
Thermo Fisher Scientific
Plumbing Connectors
61i Calibrator Connector
(optional)
Digital Outputs
Figure 4. Rear Panel Connectors
Data acquisition and external control are implemented through Ethernet,
RS-232 or a dedicated I/O system and analog outputs. If a dedicated I/O
system will be used, connections are made through terminal block PCB
assemblies with a D-Sub connector on one side and a series of screw
terminals on the other. Refer to the "Installation" chapter in the "Model
60i Instruction Manual" for detailed information on I/O configuration.
Refer to Figure 5 and Table 2 for information on analog outputs and the
most commonly used digital inputs. Refer to Table 3 for information on
optional analog current outputs and optional analog voltage outputs (I/O
expansion board 25-pin connector.)
The following terminal block PCB assemblies are available for iSeries
instruments:
I/O terminal block PCB assembly, 37 pin (standard)
●
D/O terminal block PCB assembly, 37 pin (standard)
●
25-pin terminal block PCB assembly (included with optional I/O
●
Expansion Board)
Fan
13
1
Component Side Viewed from Top of Board

Terminal Block

24
12
Model 60i Quick Start Guide 5