FLIR D-348 Installation Manual page 26

2 Basic Operation and Configuration
Server > Server Status
The Server Status page provides an indication of the current server status (either running or stopped)
and buttons for starting or stopping the server and for rebooting the system. The Uptime section of the
Server Status page shows how long the camera has been running, number of users, and the load on
the camera processor. All values are updated only when the Server Status page is first accessed.
Toggle Server
(Stop/Start)
After making configuration changes, it is necessary to save the changes to the server (there is a Save
button at the bottom of each configuration page). The configuration changes do not take effect
immediately. Generally, it is also necessary to stop and restart the server for the changes to become
effective. The server has a configuration that is active and running, and another configuration that is
saved (and possibly different than the running configuration).
The message at the bottom of the page indicates the
saved configuration is different than the active (running)
configuration, and it is necessary to restart the server.
It may take up to 20 seconds or more to stop the server, especially when there are multiple video
streams open. Be patient when stopping the server.
When the server is stopped and the page is refreshed, the status will show
Server Stopped and the Start button will be enabled.
Click on the Start button to restart the server, and when the page refreshes,
the status will again show Server Running. The Start button will be replaced
by a Stop button when the startup procedure has completed.
427-9030-01-12 Version 140 March 2018 26